I'm not the one selling this, although I'm thinking about bidding - not sure yet.

Just thought I'd give people here a heads up in case anyone was looking for an exhaust like this. It might go for a pretty good deal.

http://cgi.ebay.com/ebaymotors/Honda-599-Hornet-CB600F-Two-Brothers-Slip-on-pipe_W0QQcmdZViewItemQQcategoryZ35596QQihZ013QQite mZ230249189044QQrdZ1QQsspagenameZWDVW

Hmmmm, seems a bit much for a 2000 mile used exhaust. I'd just go new, I think it would be worth it.

Hmmmm, seems a bit much for a 2000 mile...
It's a Honda motorcycle...not a scooter. 2k is nothing... not even 1 oil change... :thinking

I was actually thinking about it cause it is nice and shiny... the Ti one is like the dull side of aluminum foil.

I'm sure you can put at least 20-30k on before you need a re-pack, right? 2000 miles isn't far from brand-new, so at less than half the cost of new, I think it's good.

What rejetting needs to be done to match the pipe? I'm staying stock, just curious.

I'm sure you can put at least 20-30k on before you need a re-pack, right? 2000 miles isn't far from brand-new, so at less than half the cost of new, I think it's good.

I believe Two Brothers says to repack at 3,000 - 5,000 miles. I think this is a little early since I have had this muffler on another 599 I had 5,000 miles and it still sounded good. Repacking is normally necessary before 20K.

What rejetting needs to be done to match the pipe? I'm staying stock, just curious.

I put a BMC air filter, Two Brothers exhaust and a Dynojet stage 1 jet kit. It definitely wakes up the hornet, especially at the higher RPMs.

This pipe sold for $202.50.

Anyone here?